Check dishes that stay wet Bosch SHPM65Z55N/01 Region: US | Content version: 2.0.0 Separate an unfinished cycle, water-holding shapes and wet plastics from a repeat drying problem on china or glass. MODEL AND MANUAL Exact model: SHPM65Z55N/01 Top controls with Start / Reset 3 sec, Delay and AutoAir. Match the full E-Nr, including /01. Manual: 9001411746_D · (0007) 640A MV Excludes: SHPM65Z55N/20; SHPM65Z55N/24; SHPM65W55N; Other SHPM / SHXM variants PREPARATION [ ] Let the cycle finish and dishes cool before unloading. [ ] Use only dishwasher rinse aid; do not add hand dish soap. [ ] Keep away from hot steam when opening a recently used dishwasher. TOOLS - No tools needed MATERIALS - Dishwasher rinse aid if the reservoir is empty FULL CHECKLIST 1. Record the selected cycle, completion evidence and which materials stayed wet. An unfinished wash cannot be used as a drying comparison. Source: Bosch SHPM65Z*** Operating instructions; pp. 13–14, 16, 34–37, 45–46 2. Check the rinse-aid supply. If low, use the rinse-aid refill task; wipe spills and latch the reservoir. Combination detergent does not replace liquid rinse aid in this manual. Source: Bosch SHPM65Z*** Operating instructions; pp. 13–14, 16, 34–37, 45–46 3. Angle concave items to let water drain and separate touching cutlery. Keep the spray paths open; use dishwasher-safe items only. Source: Bosch SHPM65Z*** Operating instructions; pp. 13–14, 16, 34–37, 45–46 4. Run an appropriate complete cycle with comparable items. The manual describes intensive drying on page 36; use its exact matching panel instructions if choosing that setting, and respect delicate-item limits. Source: Bosch SHPM65Z*** Operating instructions; pp. 13–14, 16, 34–37, 45–46 5. Let the dishes cool. Unload the lower rack first, then upper, then third rack so water from above does not wet dishes below. Compare plastics separately from china and glass. Source: Bosch SHPM65Z*** Operating instructions; pp. 13–14, 16, 34–37, 45–46 STOP CONDITIONS - Stop using the dishwasher for smoke, a burning smell, damaged wiring, an active leak or water near electrical equipment. Isolate power and water only from a safe, dry, accessible location; otherwise keep clear and request qualified help. - Do not remove the pump cover, reach into the pump, open electrical panels, bypass the door interlock or move the installed dishwasher. Refer plumbing connections, installation and repairs to qualified service. - Stop if a part is cracked, jammed, sharp, insecure or different from the matching manual. Do not force a fitting or touch hot water. Never mix cleaning products. BRANCH CHECKS Begin with: Was the wash allowed to finish before unloading? Was the wash allowed to finish before unloading? Was the wash allowed to finish before unloading? Look for cycle-end evidence; the manual uses 0:00. An unknown or interrupted cycle is not evidence of failed drying. Follow checklist steps: 1 - Yes, the cycle finished -> Continue to: Is liquid rinse aid available in the dispenser?. - No, it was opened or stopped early -> Observation and next step recorded. The observed cycle interruption or material/shape explains why this is not yet evidence of a drying fault. Correct the loading or let a suitable cycle finish before comparing. - I have not checked this, or cannot observe it safely -> Observation still needed. This check is not complete. A condition you have not observed is still unknown. Save the record and return when the preparation and observation can be completed safely; ask support if safe access is uncertain. Is liquid rinse aid available in the dispenser? Is liquid rinse aid available in the dispenser? Use the dedicated refill task if low; do not add detergent here. Follow checklist steps: 2 - The reservoir is supplied -> Continue to: Is water limited to plastics or upward-facing recesses?. - The reservoir is low or empty -> Continue to: Was rinse aid refilled with spills wiped and the lid latched?. - I have not checked this, or cannot observe it safely -> Observation still needed. This check is not complete. A condition you have not observed is still unknown. Save the record and return when the preparation and observation can be completed safely; ask support if safe access is uncertain. Was rinse aid refilled with spills wiped and the lid latched? Was rinse aid refilled with spills wiped and the lid latched? Finish the linked refill task before making a comparison wash. Follow checklist steps: 2 - Rinse aid is ready for the wash -> Continue to: Is water limited to plastics or upward-facing recesses?. - The lid will not close or the wrong product was added -> Pause and request qualified help. The observed condition needs qualified help. Keep the appliance out of use when a safety concern remains. Share the exact model, displayed message and your before/after observations; do not open panels, bypass a lock or access the pump. - I have not checked this, or cannot observe it safely -> Observation still needed. This check is not complete. A condition you have not observed is still unknown. Save the record and return when the preparation and observation can be completed safely; ask support if safe access is uncertain. Is water limited to plastics or upward-facing recesses? Is water limited to plastics or upward-facing recesses? Plastic dries differently; pooled water in a base or rim is a loading clue. Follow checklist steps: 3 - No, similar china or glass is also wet -> Continue to: How did the completed comparison wash dry?. - Yes, only plastics or recesses hold water -> Observation and next step recorded. The observed cycle interruption or material/shape explains why this is not yet evidence of a drying fault. Correct the loading or let a suitable cycle finish before comparing. - I have not checked this, or cannot observe it safely -> Observation still needed. This check is not complete. A condition you have not observed is still unknown. Save the record and return when the preparation and observation can be completed safely; ask support if safe access is uncertain. How did the completed comparison wash dry? How did the completed comparison wash dry? Compare the same types of items after correct loading and bottom-first unloading. Follow checklist steps: 4, 5 - China and glass are drier; remaining water is explained by item shape or plastic -> Observed result recorded. You recorded the drying result for comparable items after a complete cycle. This is your observation, not independent confirmation of the appliance condition. - Comparable china or glass remains wet after the full cycle -> Pause and request qualified help. The observed condition needs qualified help. Keep the appliance out of use when a safety concern remains. Share the exact model, displayed message and your before/after observations; do not open panels, bypass a lock or access the pump. - I have not checked this, or cannot observe it safely -> Observation still needed. This check is not complete. A condition you have not observed is still unknown. Save the record and return when the preparation and observation can be completed safely; ask support if safe access is uncertain. RESULT OBSERVATIONS - You recorded the drying result for comparable items after a complete cycle. YOUR RECORD Observation date: ____________________ BEFORE Wet items and cycle completion: ____________________ AFTER Comparable items after the next wash: ____________________ Additional observations: ____________________ Result / reason for stopping: ____________________ Next action: ____________________ REMINDER Choose a reminder to review this observation when the symptom recurs or care is needed; no fixed day interval is assigned. Interval: Choose a personal interval; basis: user-selected Source: bosch-manual; pp. 13–14, 16, 34–37, 45–46 A calendar reminder is a personal plan, not a record of work completed. DIAGRAMS Conceptual comparison of a level cup base holding water and an angled cup shedding water; compare plastics separately and unload the lower rack first. https://csl-13-appliance-repair.pages.dev/diagrams/bosch-drying.svg Original Homekeep schematic; conceptual identification and observation only, not an exact part drawing or official Bosch artwork SOURCES Bosch SHPM65Z*** Operating instructions | 9001411746_D · (0007) 640A MV | pp. 13–14, 16, 34–37, 45–46 https://media3.bsh-group.com/Documents/9001411746_D.pdf#page=46 Checked: 2026-10-13. Copyright BSH. Linked reference; original summaries only. No manual illustrations reproduced. Bosch SHPM65Z55N/01 appliance information | Live E-Nr /01 support page | Exact SHPM65Z55N/01 identity; associated operating instructions 9001411746_D https://www.bosch-home.com/us/en/productservice/SHPM65Z55N-01 Checked: 2026-10-13. Link only RELATED TASKS Refill the rinse-aid reservoir: https://csl-13-appliance-repair.pages.dev/tasks/bosch-rinse-aid/ Arrange a load with clear spray and vent paths: https://csl-13-appliance-repair.pages.dev/tasks/bosch-loading/ Check why AutoAir did not open the door: https://csl-13-appliance-repair.pages.dev/tasks/bosch-autoair/ Observations do not certify a physical repair. Follow your matching supplied manual and the stop conditions. Guide: https://csl-13-appliance-repair.pages.dev/tasks/bosch-poor-drying/